Icom IC-450 / IC450 80 Channel UHF CB Radio

Brand: Icom Australia
Product Code: IC-450
Price:
$493.90 $381.70

Next Generation UHF CB! Now with Noise cancelling microphone and voice recording.

Icom Australia 5 Year Warranty

The ICOM IC-450 Mobile Two Way Radio provides all controls in the palm of your hand. The incredible IC-450 CB mobile is designed to the highest specifications to deliver unmatched performance for Australia's demanding UHF CB mobile radio market.

Today, ICOM is regarded as one of the World's leading radio manufacturers. Extensive Research & Development facilities enable ICOM to design, develop and customise communications equipment to better meet Australia's specific market needs.

The ICOM IC-450 UHF CB is pre-programmed for instant communication on the standard Australian 80 UHF CB channels - So there is no need to worry about ongoing licensing fees.

  5 Watts (High) and 1 Watt (Low) Selectable Output Power
  80 CB Channels plus up to 35 receive only Channels
  Noise Cancelling Microphone
  Voice Recorder allowing up to 10 messages recorded with a total recording time of 5 minutes (30 seconds per message)
  Built-in Speaker
  12 or 24 Volt automatically detected
  Voice Guidance which announces channel type and number
  Small and compact for installation
 
  New design, compact control speaker microphone with newly designed user interface and menu structure
 
 

General

• Frequency coverage
CB: 476.425–477.4125 MHz
RX: 450.000–520.000 MHz (RX only)
• Mode: 8K50F3E
• Number of channels: Max 128ch/8 banks
• Antenna impedance: 50 W
• Input impedance: 600 W
• Output impedance: 4 W
• Intermediate frequency: 1st 46.35 MHz, 2nd 450 kHz
• Operating temperature range: –10°C to +60°C
• Power supply voltage: 13.8 or 27.6 V DC nominal
(Negative ground)
• Current drain with HM-212 (approximately)
DC 13.8 V: RX stand-by 500 mA
RX Maximum audio 1500 mA
TX (5 W) 2000 mA
DC 27.6 V: RX stand-by 300 mA
RX Maximum audio 1000 mA
TX (5 W) 1300 mA
• Dimensions: 125 (W) × 29 (H) × 180 (D) mm
(Projections not included)
• Weight (approximately): 1011 g (with HM-212)

Transmitter

• Output power: 5 W/1 W (selectable)
• Modulation system: Variable reactance frequency modulation
• Max. frequency deviation: ±2.5 kHz
• Frequency error: ±2.5 ppm
• Spurious emissions: Less than –30 dBm
• Adjacent channel power: Less than –16 dBm
• Audio harmonic distortion: 1% typical (60% deviation)
• Residual modulation: 40 dB typical
• Limiting characteristic of modulator: 70 to 100% of maximum deviation

Receiver [CB (476.425–477.4125 Mhz)]

• Sensitivity (12 dB SINAD): 0.22 µV typical
• Squelch sensitivity: 0.2 µV typical (Threshold)
• Hum and noise: 48 dB typical
• Intermodulation rejection ratio: 72 dB typical
• Spurious response rejection ratio: 80 dB typical
• Adjacent channel selectivity: 68 dB typical
• Conducted spurious radiation: Less than –57 dBm
(9 kHz–1.0 GHz)
Less than –47dBm
(1.0 GHz–4.0 GHz)
• Audio output power: 5.0 W typical at 10% distortion with a 4 W
load
• Audio frequency response: +2 dB to −8 dB of 6 dB/octave from
300 Hz to 2550 Hz
(at the 1 kHz reference)

Receive Only Channels [RX (450.000–520.000 Mhz)] (except CB (476.425–477.4125Mhz))

• Sensitivity (12 dB SINAD): 0.25 µV typical
• Hum and noise: 45 dB typical
• Conducted spurious radiation: Less than –57 dBm
(9 kHz–1.0 GHz)
Less than –47 dBm
(1.0 GHz–4.0 GHz)
• Audio frequency response: +2 dB to –8 dB of 6 dB/octave from 300
Hz to 2550 Hz
(at the 1 kHz reference)

 
 
 

Microphone HM-212

OP2355 2.5m Microphone Extension Cable

DC Power lead

Spare Fuse

Mounting Bracket (Radio)

Mounting Bracket (Microphone)

 

Submit a question about Icom IC-450 / IC450 80 Channel UHF CB Radio


Name:


Email:


Question:

Enter the code in the box below:



Write a review

Your Name:



Your Review:

Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:





#{message}
#{time_ago}